MAINTENANCE AND CLEANING
1.
Turn off the air supply to the tank.
2.
Relieve all air pressure in the tank by loosening air release valve until no air pressure remains.
3.
Remove the lid from paint tank and empty remaining material.
4.
Clean tank and parts which come into contact with paint with a suitable solvent.
5.
Pour solvent into tank and replace lid.
6.
Spray until clean solvent appears.
7.
Repeat steps 3 and 4 as necessary.
OPERATION
1.
Turn on the air supply and adjust air pressure to approximately 45 psi.
2.
Turn the handle adjusting screw clockwise on the air regulator to increase material pressure.
NOTE: IT IS RECOMMENDED THAT MATERIAL PRESSURE BE KEPT AS LOW AS
POSSIBLE - NORMAL OPERATING PRESSURE SHOULD NOT EXCEED APPROX 15 PSI.
3.
WARNING -
Air pressure loads higher than design loads, or alterations to the
pressure tank can result in tank rupture or explosion. Do not make any changes to the
pressure tank. Do not weld, drill or otherwise tamper with the pressure tank.
4.
A safety valve protects the tank from over pressurization. Prior to each use pull the ring on the
safety valve to check it operates freely and relieves air pressure. If it does not operate freely or
does not relieve air pressure it must be replaced. Do not discard or make adjustments to this valve.
5.
Atomization air for the spray gun should be adjusted with the use of an air adjusting valve attached
to the air inlet of the spray gun.
6.
Operate the spray gun according to the manufacturers recommendations..
7.
To refill paint always relieve all air pressure in the tank by loosening air release valve Part 26,
until no air pressure remains in the container.
8.
Unscrew the lid assembly and remove.
9.
Pour material into the tank.
10. Replace lid assembly and tighten securely.
INSTALLATION
Follow the manufacturers recommendations for the mixing preparation of the material. Strain the mate-
rial using a fine mesh screen in order to prevent the entry of foreign matter and clogging of the passage-
ways.
1.
Always relieve all air pressure in the tank by loosening air release valve Part 26, until no air
pressure remains in the container—the gauge will read ‘0”.
2.
Unscrew the lid assembly and remove.
3.
Pour material into the tank.
4.
Replace lid assembly and tighten securely.
5.
It is best for the air supply line to pass through a filter element to remove any dirt, water and oil.
Connect the air supply line to the air inlet fitting on the regulator.
6.
Attach the atomizing air hose to the air outlet on the tank regulator. This is directly opposite the
air inlet fitting.
7.
Connect the material hose to the fluid outlet fitting.
DESCRIPTION
This 2 litre pressure tank provides pressurized material. This tank is equipped with an air regulator,
gauge, safety valve, release valve and fluid outlet.
This tank can be used for delivery of material other than paint.
It is not designed for use with highly abrasive, corrosive or rust inducing materials.
WARNING -
DO NOT USE
ANY HALOGENATED HYDROCARBON SOLVENTS eg METHYL CHLORIDE
ANY INFLAMMABLE OR TOXIC PRODUCTS eg PETROL, KEROSENE
ANY HERBICIDES OR PESTICIDES
ANY RADIOACTIVE FLUID
Содержание PT.2
Страница 1: ...PT 2 Instruction Manual February 2018...
