Anest Iwata DDP-70B, Инструкция по эксплуатации

Страница: 25 / 34

- 23 -
Screw hole for pump
Fixation M6×1
55
28
■
5. Before operation
5-1. Installation, connection and inspection
• Securely connect hose to avoid leaks and looseness. If hose is disconnected during operation, hazardous
hose movement and paint ejection will cause severe bodily injury.
• Securely ground pump, spray gun, workpiece and containers containing paint or solvent.
Insufficient grounding will cause explosion or fire by spark of static electricity.
• Install or keep pump free of rain or splashes. If not done, it can cause pump failure.
• Install pump free of paint mist. Attached paint mist etc., can cause pump failure.
• Use clean air filtered through dryer and filter (finer than 50 microns).
If not done, it can cause pump failure.
• Install pump free of paint mist.
Attached paint mist etc., can cause pump failure.
(1) Setting for pump
Job 1
Please confirm two holes (M6) are created in
the lower adaptor of pump.
Job 2
Please lock two bolts (M6) certainly.
(2) Connecting suction tube
Connect suction tube on the fluid inlet on the
diaphragm pump.
Ensure attaching suction filter on the suction
tube.
5-2Check operation
- Do not idle pump operation. Idle operation can cause pump failure.
- Flush fluid passages of this unit completely with cleaning fluid (3
~
4 l). When first use or not-use for a long
poriud.
Please open the ball valve (for air) to operate pump.
- Do not use the following paints which can
causepump failure.
- contains big solid matter,
- contains solid matter of sharp shape,
- has corrosivenss (except for PH6~8).
Open ball valve
(for air)
0.15〜0.7MPa
Air hose
（Option）