Anest Iwata Classic plus Series, Инструкция по эксплуатации

Страница: 5 / 24

5
GB
Classic Plus Series Classic Plus Series
GB
6. TROUBLESHOOTING
GUN DOES NOT SPRAY
- Fluid adj. knob (12) closed. Check and adjust.
- Tip hole of nozzle obstructed. Check and clean.
- Paint filter obstructed. Check and clean.
- Non drip obstructed. Check and clean.
INTERMITTENT SPRAY PATTERN
- Air escapes from fluid nozzle Check , clean & replace if
(2-1). necessary.
- Air escapes from fluid needle Tighten.
packing (21).
- Air escapes from cup joint. Tighten.
- Dirt inside air cap (1). Clean.
DEFECTIVE SPRAY PATTERN
- Dirty nozzle (2-1) or air cap (1). Clean carefully.
- Nozzle (2-1) or air cap (1) Replace If damaged.
has been damaged.
- Fluid nozzle (2-1) is loose. Tighten.
- Paint viscosity too high or Dilute paint or increase
too low. viscosity
- Fluid output too high or Adjust fluid adj. knob (12)
too low. to reduce or increase.
LEAKING
- Fluid nozzle (2-1), needle set Clean or replace if neces-
(2-2) or gun body (5), dirty, sary.
damaged or worn on seat.
- Dirt inside air cap (1). Clean.
- Loose fluid adj. knob (12). Adjust.
- Fluid needle spring (11) is Replace.
worn.
- Loose fluid nozzle (2-1). Tighten.
- Needle packing set (21) loose, Adjust, clean or replace.
too tight, dirty or worn.
AIR ESCAPES FROM AIR CAP
- Air valve (8), air valve seat (7) Clean or replace if neces-
or air valve spring (9) dirty sary.
or damaged.
- Air valve seat set o ring Replace.
(7-1) damaged or worn.
7. SPARE PARTS LIST
n
Marked parts are wearable parts.
NOTE:
When ordering parts, specify gun model, part name with No. and
marked No. of air cap set, fluid nozzle and fluid needle.
REF. DESCRIPTION
1 Air cap
2 Fluid Fluid needle set
n
2-1 Fluid Nozzle
n
2-2 Fluid needle
n
5 Body set
5-1 Air nipple
5-2 Fluid nipple*
6 Pattern adjustment set
7 Air valve seat *
7-1 O’ring
n
8 Air valve
n
9 Air valve spring
10 Fluid adjustment guide
11 Needle spring
12 Fluid adjustment knob
13 Air valve shaft
n
14 Air adjustment set
15 Trigger stud
16 Trigger
17 E stopper
18 Filter 60 Mesh
19 Brush
20 Universal spanner
21
Needle Packing set
n
22 Cup 600 cc
22-1 Lid
22-2 Knob
*ATTENTION: To disassemble Air valve seat_ part. 7,
use 10 mm allen wrench
(Non ball point type).
To disassemble Fluid nipple_ part. 5-2, use 8 mm allen wrench.
6
7
7-1
13
8 9 10
2-2
11 12
5-1
14
15
17
16
1
20
21
19
2-1
5-2
18
22
22-2
22-1