4. East Section Assembly
For more information visit AndyMark.com/Table
1X - Interconnect A
1X - Interconnect B
1. Align walls to edges of panel with the flat side of the
panel facing up. Each hole in the panel should line up with
a corresponding hole or thraeded insert in each wall.
1X - Outer Panel
12X - Washer
12X - Screw
8X - Spacer
2. Insert the Interconnects into the walls so that it lines up
with the holes in the wall and panel and the back of the
angle is facing towards the inside of the table. Use a screw
and washer to secure the wall and Interconnect to the
panel. Leave these screws loose until all screws are
installed.
3. Add a screw, washer and spacer to each of the remaining
panel holes. Thread the screw into the threaded insert and
leave loose until all the screws are installed.
Screw
Outer Section Side Wall
Washer
Interconnect B
Screw
Spacer
Washer
4. Adjust the walls and ensure the outside edges of each wall
are aligned with the edge of the base panel. Using an 1/8”
allen wrench, secure wall sections to the base panel.
2X - Outer Section Side Wall
1X - East Wall
East Wall
Outer Section Side Wall
Interconnect B
Outer Section Panel
l
Outer Section Side Wall
Interconnect A
