Laser Detection at its Best
Page 5
Setting the numeric elevation display unit:
Press the buttons
[15]
und
[16]
at once cycles through
the display units:
>
mm:
Millimetre
>
cm:
Centimetre
>
in:
Inch
>
F.in:
Fractional Inch
Instruction Manual
Digital Laser Receiver Metor
Model: MTR-60R
Battery (Fig. A/D)
Inserting / changing the battery
!
Change the battery if is displayed .
!
Open the battery compartment by unlatching the
battery door
[12]
.
!
Remove the battery and insert a new one
(observe correct polarity!).
!
Dispose of the used battery (see chapter on
environmental protection).
NOTE: Make sure that the device is in
vertical position and that the laser-
sensitive area
[5] is not partially covered
during measurement. This can entail
false measuring results.
Operation
Switching the device on / off
To switch on the device, press the On / Off button
[15]
. To switch off the device, press and hold the On
/ Off button
[15]
for more than two seconds until a
confirmation beep sounds.
Adjusting the volume
!
Pressing the beeper volume button
[15]
cycles
trough the following options:
>
High: Beeper symbol permanently displayed;
text "Hi" for one second
>
Low:
Beeper symbol permanently displayed;
text "LOW" for one second
>
Off:
No Beeper symbol displayed;
text "OFF" for one second
Adjusting the accuracy
!
Press accuracy button
[16]
once to numerically
display current accuracy setting on the LCD. Press
again, while the accuracy is displayed (within one
second), to change the current selection.
!
Fine
Medium
Coarse
1.0
2.0
5.0
0.1
0.2
0.5
0.05
0.1
0.2
1/8
1/4
1/2
mm
cm Inch Fract.In. Display
Maintenance and Care
Keep the device always clean, especially the
laser-sensitive area!
!
Do not use aggressive cleaning solvents.
!
If soiled heavily, the device can be cleaned under
running water.
!
Do not use high-pressure cleaner.
!
Allow the device to dry completely before storing
it in a closed container. Residual moisture can
result in corrosion of the battery contacts. In this
case our warranty expires.
!
In the unlikely event of a failure or defect, have
the appliance examined and repaired by
AndroTec.
!
In all your queries and spare part orders, always
quote the 8-digit serial number (see type plate) of
your device.
Environmental Protection
Do not dispose of the device with domes-
tic waste. Have the device disposed of by
an authorised waste management
company or your municipal waste mana-
gement organisation.
Adhere to the applicable regulations. In case of doubt
contact your waste management organisation.
Recycle all packaging material in an environmentally
friendly manner.
Batteries:
Do not dispose of batteries with domestic waste, do
not expose them to fire or water. Collect and recycle
batteries or dispose of them with due care for the
environment.
Activate / deactivate LEDs
Press the LED button
[16]
for more than two seconds to
change the LED display. If activated, the
measurements are shown by the LEDs in addition to
the display.