14
Connecting Quick Connect Cord-2
Connecting the Quick Connect Cord-2 to the two units.
1. Turn off the power.
2. Remove the front cover of the heater (4 screws).
3. Pass the Quick Connect Cord-2 through the wiring
throughway and into the unit.
4. Plug the connector on the Quick Connect Cord-2
to the receptacle inside the unit.
5. Attach the ground wire of the Quick Connect Cord-2
to the terminal block fi xing plate.
(If the ground wire is not attached, electrical noise
may cause problems).
6. Secure the Quick Connect Cord-2 with a clamp.
7. Replace the front cover.
Wiring Throughway
Coupling Cord
Clamp
Ground wire Connector
(Use one of the vacant holes)
Connector
Caution
For Quick Connect Multi System Installation use part Quick Connect Cord-2 only. (sold separately).
Quick Connect
Cord-2
"Quick Connect Cord-2" tag
A
B
1.Red
2.Black
3.White
4.Green
5.Blue
6.Blue
1.Red
2.Black
3.White
4.Green
5.Blue
6.Blue
1.Red
2.Black
3.White
4.Green
5.Blue
6.Blue
1.White
2.Green
3.Red
4.Black
5.Blue
6.Blue
The wire coloring on the Quick Connect Cord-2 will
not be the same as the wire coloring of the
connection plug inside the unit.
* The remote controller can be connected to
either unit A or B. Do not connect a remote
controller to both units.
* Disconnect the remote controller from either
unit A or B prior to installing the Quick Connect
Cord-2.
