How to Use
1.
Fill the water tank in between the minimum and the maximum level. When
water is added to the dispenser, it is filtered through the Strix Filter and so
doesn’t immediately appear in the water window.
2.
Place your cup on the removable water tray, and make sure it aligns with the
spout.
3.
Plug the appliance in at the socket and make sure it’s on.
4.
Press and hold the LOCK button for three to five seconds to unlock the device.
5.
Press the TEMP button to select the desired water temperature. The
temperature goes up in the following increments: 0 (room temp)
45/55/65/75/85/100.
Press the VOLUME button to chose the amount of water to be dispensed. The
volume goes in the following ML increments: 100/200/300/000 (the water will flow
continuously).
7.
Press the OK button to begin the operation. If you have selected 000, press the
OK button a second time to cancel the operation.
8.
When the drip tray is full, lift it away from the appliance body and empty it.
Please note: If you get an E7 error message it means you have run out of water.
Simply refill the reservoir to remove it.
This appliance has a memory function. To automatically use the previous settings
after the water has finished dispensing, unlock the appliance and press the OK
button once. If you unplug the Purify Hot and Cold Water Dispenser from the wall,
the memory function will not work.
Changing the Universal Filter
The filter has a 150L life span, which is around 4
-
6 weeks of normal use. Store your
replacement filters in a cool place, away from direct sunlight and heat.
1.
Remove the filter from the packaging. There may be small black carbon
particles in the bag or on the filter, this is normal.
2.
Soak the filter upright in water for 10 minutes.
3.
Rinse the filter under running water for 10 seconds.
4.
Place the filter into the water dispenser. It is now ready to use.
Please note: you can use this product without the filter.