andover SPINDECK, Руководство по эксплуатации продукта

Страница: 5 / 12

Page 5
To Set-up your Spindeck MAX
1. Remove the two transportation locks
(Fig. 1) by applying lateral pressure.
The locks are located on the floating
subchassis at the front left and at the
rear right.
IMPORTANT: Please retain these
locks and reinstall them whenever
your Spindeck MAX requires
shipment.
2. Place the platter over the center
spindle and press down until the two
wire springs snap into the groove of
the spindle. Place the felt mat on the
platter.
IMPORTANT: If your Spindeck MAX
ever requires shipment, please
remove the platter and place it under
the turntable in the carton. If this is
not done the platter may become
dislodged in shipment and cause
damage to the tonearm, dustcover or
cartridge.
3. Insert the two cover hinges into the
slots at the rear edge of the plinth.
Slide the notches in the cover into the
slots at the top edge of the hinges.
Press the spring wires until they click into the spindle groove.