Andover Controls DCX 250, Руководство по установке

Страница: 19 / 29

Hardware Installation
DCX 250 Installation Guide 11
5. Tighten the screw with a flathead screw driver.
Figure 5 shows the position of the plate, where to place the wire, and
how the screw fits on the plate. You can see how the screw holds
the plate in place once you tighten it.
Figure 5. Metal Plate and Screw for Power Supply Wire
6. Place the white wire under the metal plate behind the middle screw,
labeled NEUT.
7. Tighten the screw with a flathead screw driver.
8. Place the black wire under the metal plate behind the right screw,
labeled HOT.
9. Tighten the screw with a flathead screw driver.
Connecting the Infinet
You wire the Infinet to the controller using the following procedure:
1. Lift off the front display panel on the DCX 250 controller cabinet.
Look at the board now directly in front of you.
Figure 6 shows the Infinet connection, a block terminal connector in
the upper right corner. You must wire Infinet to that connector.
2. Thread the Infinet cable through the cutout in the top of the
controller.
Insert Wire Here
Metal Plate
www.PDF-Zoo.com