Copyright © 1992 Andover Controls Corporation, 300 Brickstone Square, Andover, MA 01810 All Rights Reserved.
Click for EMX Menu
Your warranty is effective for 18 months starting on the
date the system is shipped.
Before You Begin
You can connect one or more EMX modules to most Infinet
controllers that have an expansion port. The particular con-
trollers are covered in the ACC EMX Modules Configuration
Guide (also enclosed with this product).The configuration
guide also tells how many inputs and outputs are allowed for
any particular controller. Before you proceed, be sure the
controller allows modules and the number and type of mod-
ules you plan to use.
Warning
Be sure wiring and installations comply with local, state,
and national electrical codes.
Figure 1 shows the EMX 156 module.
Figure 1. The EMX 156 Module
Dimensions
Each EMX 156 module is approximately 3.75
×
4.25 ×
1.5 in.
EMX156
BOARD
OUTPUT
A
OVERRIDE
A
B
OUTPUT
B
LOAD
A
LOAD
B
DATE
1
2
U
L
INPUTS
VOLTS 24V
AMPS
36MA
OUTPUTS
VOLTS 240V
AMPS 3.5A
LISTED
ACCESSORY EQUIPMENT
58B2
FOR USE WITH
SCX
LCX AND TCX UNITS
,
24VDC
CLASS
I I
AUTO OFF ON AUTO OFF ON
R
Power Requirements
The EMX 156 consumes up to 32 mA at 24 VDC.
For power requirements when installing multiple modules
see the ACC EMX Modules Configuration Guide.
Environmental Requirements
The EMX 156 operates in the same environment that any
Infinet controller operates in.
Output Characteristics
The two outputs are Form A (SPST) AC outputs with
override and feed back detection.
All outputs may be programmed or set with manual over-
ride switches.
The Form A outputs are rated for 3 A at 24–280 VAC.
Install the EMX 156
1. Unpack
Be careful when unpacking the unit or units to not damage
the packaging material—you must reuse it if you ship the
product back for repair.
2. Connect to the Infinet Controller
Connect the module to the Infinet controller as follows:
Caution
Be sure you disconnect the Infinet controller’s AC power
source before you connect any modules.
1.Look at the bottom panel of your Infinet controller. On
that panel is an expansion port in approximately the
center of the panel.
2.Look at the EMX 156 module. Notice that it has a
connector on the top and on the bottom. Plug the top
connector into the Infinet controller.
ACC EMX 156
Installation Guide
Order No. 30-3001-349
Version 1.3
www.PDF-Zoo.com
