8
the blade set in one hand, and slide the blade from side-to-side to remove
any trapped hair or debris (Figure E).
MOUNTING AND DISMOUNTING THE BLADE SET
The blade set should be attached with the clipper turned OFF. When
removing the blade, turn the clipper off. Push the blade away from the
clipper with your thumb, and the blade will pop off (Figure F). To replace
or change the blade set, fit the black plastic tab on the blade set into the
notch located at the bottom of the clipper opening. Firmly push the blade
onto the clipper housing, and it will snap into place (Figure G).
IMPORTANT:
Frequently remove accumulated hair from the cavity under
the blade set. Remove the blade set as described above and brush hair
from the cavity using a small brush, toothbrush or Andis Dry Care.
USE GUIDELINES FOR LITHIUM-ION BATTERIES
1. The lithium-ion battery included with your clipper does not develop a
“memory effect” like a nickel-metal hydride (NiMH), or nickel cadmium
(NiCd) battery. You can plug the adapter cord into the clipper at any
time for a full charge, or even use the battery before a charge cycle is
complete. Like most rechargeable batteries, lithium-ion batteries
perform best when used frequently.
2. For maximum battery life, store the clipper in a partially discharged
condition if the unit will be unused for several months.
3. Do not store clipper under 50°F or over 104°F. Do not expose clipper to
excessively damp conditions.
4. Avoid locating the clipper near heat vents, radiators, or in direct
sunlight. Optimum charging will result where the temperature is stable.
Sudden increases in temperature can result in the battery receiving less
than a full charge.
5. Many factors influence lithium-ion battery life. A battery that has
received heavy use or is more than a year old may not give the same
run-time performance as a new battery pack.
6. New lithium-ion batteries, unused for a period of time, may not accept a
full charge. This is normal and does not indicate a problem with the
battery or charger. The battery will accept a full charge after several
cycles of clipper use and recharging.
7. Disconnect the adapter cord from the AC outlet if extended periods of
non-use are anticipated.
