Ancona WPC630, Руководство пользователя и инструкции по установке

Страница: 22 / 23

2 2
Maintenance:
SAFETY WARNING: Never put your hand into area housing the fan while the fan is operating!
For optimal operation, clean range hood and all baffle/spacer/filter/oil container regularly. Regular care will help preserve
the appearance of the range hood.
Cleaning Exterior surfaces:
• Clean periodically with hot soapy water and clean cotton cloth. DO NOT use corrosive or abrasive detergent (e.g.
Comet Power Scruv ® , EZ-Off ® oven cleaner), or steel wool/scoring pads, which will scratch and damage the stainless
steel surface. For heavier soil use liquid degrease such as “Forumla 409
®
” or “Fantastic
®
” brand cleaner.
•
If hood looks splotchy (stainless steel hood), use a stainless steel cleaner to clean the surface of the hood. Avoid getting
cleaning solution onto or into the control panel. Follow directions of the stainless steel cleaner. CAUTION: DO NOT
leave on too long as this may cause damage to hood finish. Use soft towel to wipe off the cleaning solution, gently
rub off any stubborn spots. Use dry soft towel to dry the hood.
• After cleaning, you may use non abrasive stainless steel polish such as 3M
®
or ZEP
®
, to polish and buff out the stainless
luster and grain. Always scrub lightly, with clean cotton cloth, and with the grain.
• DO NOT allow deposits to accumulate or remain on the hood.
• DO NOT use ordinary steel wool or steel brushes. Small bits of steel may adhere to the surface and cause rusting.
• DO NOT allow salt solutions, disinfectants, bleaches, or cleaning compounds to remain in contact with stainless steel
for extended periods. Many of these compounds contain chemicals, which may be harmful. Rinse with water after ex-
posure and wipe dry with a clean cloth.
Cleaning Stainless Steel Baffle Filter:
IMPORTANT: Drain oil from baffles, spacers, filters, oil tunnels, oil containers before oil and residue overflow!
• Remove all baffles, spacers, filters, and oil containers and discard oil and residue.
• Wash with warm soapy water. NOTE: Stainless steel baffles, spacers and oil tunnel are top rack dishwasher safe.
• Dry thoroughly before replacing and follow directions for installation in reverse.
• Filters should be cleaned after every 30 hours of use.
Replacing Filters:
• Should filters wear out due to age and prolonged use, replace with following part number:
PA02023(AN-1147)
PA02024 (AN-1148)
Replacing the light bulb:
1
Remove baffle filter as per installation.
2
Make sure the hood is disconnected or close the
circuit breaker. R each into the range hood and
disconnect power clip .
3
Reach into interior of range hood until touching both
lateral clips located on the side of the puck light.
Gently squeeze and push down until puck pops out
from its location.
4 To reinstall new puck light, follow instruction
3
in reverse order.