— 8 —
Installation
STEP 1
Read the Safety Instructions
•
It is very important to read the safety instructions on pages 4 and 5.
IMPORTANT: It is the installer’s responsibility to
comply with installation clearances.
NOTE: Use threaded drywall anchors only when
mounting the hood on sheet rock. Mounting the
hood on wall studs or lumb
e
rs is highly recommended.
STEP 2
Unpack Range Hood and Prepare Tools
•
Carefully unpack the range hood and parts. Make sure all parts are included as shown on page 6.
•
DO NOT remove the protective film covering the appliance until the installation is fully completed
•
Consult a qualified and trained installer or check local codes for makeup air
r
equirement, if any.
STEP 3
Plan Desired Location
•
Plan a desirable location that fits all
r
equirements in the Safety and Installation sections of this manual. Plan
where
and how the ductwork will be installed.
•
A straight or short duct run will allow the unit to perform most efficientl
y
. Long duct runs, elbows and transitions
will reduce the performance of the unit. Each elbow is equivalent to 5 to 10 feet of straight run. Proper size duct
work should be 6” (152 mm) in diameter.
•
To reach a 9 foot ceiling make sure hood is installed 30 inches from cooking surface. If you have a ceiling
greater than 9ft, please visit anconahome.com to order a chimney extension.
•
If ductwork is already installed: ensure ductwork is free from debris and measures 6” (152 mm).
STEP 4
Test Unit Functions
•
Plug the unit in and test all of the functions before installing.
WARNINGS:
•
Please make sure to read ALL safety inst
r
uctions on pages 4 and 5.
•
Use two or more people to move and install range hood.
• Failur
e to follow these instructions can result in serious injury
.