— 10 —
Important Safety Information
GAS CONNECTIONS (All Units)
Important:
Do not apply pressure directly to the appliance
manifold pipe when tightening supply connections. The
manifold pipe should be held securely at the pressure
regulator to prevent twisting. Hold the pressure regulator
with a wrench during the tightening of the connection, or
the manifold pipe may be twisted and split and cause a
dangerous leak.
Note:
Check all piping connections in the unit for leaks.
Never use an open
fl
ame to check for gas leaks. Use a soap
solution, 75% water, 25% dish washing soap. It is possible
for connections made at the factory to leak, due to vibration
encountered in transportation. Make certain you have
checked them all, and repair any connections that leak.
r 5IFBQQMJBODFBOEJUTJOEJWJEVBMTIVUPGGWBMWFNVTUCF
disconnected from the gas supply piping system during
any pressure testing of that system at test pressures in
excess of 1/2 psig.
r 5IFBQQMJBODFNVTUCFJTPMBUFEGSPNUIFHBTTVQQMZ
piping system by closing its individual manual shut-off
valve during any pressure testing of the gas supply piping
system at test pressures equal to or less than 1/2 psig.
GAS LINE SHUT-OFF VALVE
r 5PSFEVDFUIFQPTTJCJMJUZPGHBTMFBLTBQQMZ5FáPOUBQF
or a thread compound approved for use with LP or
Natural gases to all threaded connections.
r *OTUBMMBNBOVBMHBTMJOFTIVUPGGWBMWFJOUIFHBTMJOF
in an easily accessed location outside the range in the
gas piping external to the appliance for the purpose of
turning on or shutting off gas to the appliance.
r *OTUBMMNBMF PSJODISBOHFUPQPSu
JODISBOHFUPQáBSFVOJPOBEBQUFSUPuPS/15
internal thread elbow at inlet of regulator. Use a wrench
on the regulator
fi
tting to avoid damage.
r
Install male 1/2” or 3/4”
fl
are union adapter to the NPT
internal thread of the manual shut-off valve, taking care
to secure the shut-off valve to keep it from turning.
ELECTRICAL DANGER
Electrical Shock Hazard.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fi
re, or electrical shock.
r "OZBEEJUJPOTDIBOHFTPSDPOWFSTJPOTSFRVJSFEJOPSEFS
for this appliance to satisfactorily meet the application
needs must be made by a quali
fi
ed service technician
JOBDDPSEBODFXJUIUIFNBOVGBDUVSFSTJOTUSVDUJPOT
and all codes and requirements of the authority having
jurisdiction. Failure to follow the instructions could
result in serious injury or property damage. The quali
fi
ed
agency performing this work assumes responsibility for
the conversion.
r %0/05PQFSBUFUIJTBQQMJBODFVTJOHBQSPOHBEBQUFS
or an extension cord. If a 2-prong wall receptacle is the
only available outlet, it is the personal responsibility
of the consumer to have it replaced with a properly
grounded 3-prong wall receptacle installed by a
quali
fi
ed electrician.
r 4FWFSFTIPDLPSEBNBHFUPUIFSBOHFNBZPDDVSJG
the appliance is not installed by a quali
fi
ed installer or
electrician.
r 5IJTBQQMJBODFJT7)[*UJTSFDPNNFOEFEUP
connect to a 15-Amp or 20-Amp power supply.
r 5PUBM*OQVU1PXFSJTL8 "/L8 "/
2161), 27.5 kW (AN-2162), 3 A for range tops. Total
Input Power is 23.4 kW (AN-2230SS/BK/WHT), 30.2
kW (AN-2236SS/BK/WHT), 41.1 kW (AN-2248SS/BK/
WHT), 5 A for ranges. A dedicated circuit, protected by a
minimum 15 to 20-amp time delay fuse or circuit breaker
is required.
r 'PSQFSTPOBMTBGFUZUIFBQQMJBODFNVTUCFQSPQFSMZ
grounded.
r
The power supply must be the correct polarity. Reverse
polarity will result in continuous sparking of the
electrodes, even after
fl
ame ignition. If there is any doubt
as to whether the power supply has the correct polarity
or grounded, have it checked by a quali
fi
ed electrician.
WARNINGS:
r &MFDUSJDBM(SPVOEJOH*OTUSVDUJPOTUIJTJOEPPSHBT
cooking appliance is equipped with a three-prong
(grounding) plug for your protection against shock
hazard and should be plugged directly into a properly
grounded three-pronged receptacle.
r %POPUDVUPSSFNPWFUIFHSPVOEJOHQSPOHGSPNUIF
plug.
r
Caution: label all wires prior to disconnection
when servicing controls. Wiring errors can cause
improper and dangerous operation. Verify proper
operation after servicing.
