— 14 —
Installation
STEP 10
Install Chimney
•
Install chimney brackets on hood body as shown on Figure #4.
•
Place chimney on top of the main housing. Remove the protective coating
from the upper chimney. Carefully slide the upper chimney down into
the lower chimney. Make sure upper chimney is moving freely.
•
Install both chimneys and tighten screws B to secure the lower
chimney to the range hood as shown in Figure #5.
•
To avoid scratching the chimney, extend the upper chimney slowly and
carefully to the chimney-mounting bracket and tighten screws as shown
in Figure #6.
GROUNDING INSTRUCTIONS:
• This appliance must be grounded. In the event of an electrical short-circuit, grounding reduces the risk of electric
shock by providing an escape wire for the electric current.
• This appliance is equipped with a cord having a grounding wire with a grounding plug. The plug must be plugged into
an outlet that is properly installed and grounded.
WARNING:
Improper grounding can result in a risk of electric shock.
• Consult a qualified electrician if the grounding instructions are not completely understood, or if doubt exists as to
whether the appliance is properly grounded. DO NOT use an extension cord. If the power supply cord is too short,
have a qualified electrician install an outlet near the appliance.
STEP 11
Install Grease Tunnel
The baffle filters and grease tunnel should be
cleaned once a month, or as needed.
•
Angle tunnel towards edge at rear end of unit.
•
Rotate and insert in the bottom end of opening
(Figure #7 and Figure #8).
Figure #8
Figure #7
Figure #6
Figure #4
Figure #5