Page 10
,QVWDOODWLRQ
Installations
(refer to Page 4 for parts)
:
1.
1. You have
two ways
(A or B) to mount this range hood:
A–1.
A–2.
A–3.
A–4.
B–1.
B–2.
B–3.
B–4.
B–5.
Proceed if you would like to mount this range hood
without
using the hood-mounting bracket.
Using references in
Height & Clearance
on Page 5 and
Measurements and Diagrams
on Page 16, cen-
ter the hood beneath the cabinet and flush with the front of the cabinet.
Draw electrical wires through cabinet access opening and center the hood beneath the cabinet.
From inside of the hood, place screws into the exact center of each knockout hole and secure to cabinet
bottom. Finish tightening all screws until secure. Be careful when using electrical screwdriver, damage
to the range hood may occur. Skip Part B below and proceed to Step 2.
CAUTION: Make certain the range hood is secure before releasing!
Height & Clearance
Measurements and Diagrams
CAUTION: Make certain the range hood is secure before releasing!
2. For safety purpose, pre-drilled mounting holes are provided through the back of the hood. For a more secure
installation, use as many mounting holes as needed to secure from the inside of hood.
3.
se r u stee
e
w u
c es ur re t c
ect t e e
ust t e
t t e uct
work above. Use silver tape or duct tape to make all joints secure and air tight. Refer to Figure 6.
SAFETY WARNING: Risk of electrical shock. this range hood must be properly grounded. Make sure this
is done by qualified electrician in accordance with all applicable national and local electrical codes. Before
connecting wires, switch power off at service panel and lock service panel to prevent power from being
switched on accidentally.
4. Connect the range hood to a designated standard outlet (120-Volt, 60Hz, AC only) or cut off the plug and con-
nect three wires (black, white and green) to house wires and cap with wire connectors. Connect according to
colors (i.e. black to black, white to white, and green to green) as shown in Figure 7.
Figure 4
Figure 3
Figure 5