CONNECTING ANCHOR AIR WIRELESS
COMPANION SPEAKER
CHANGING FREQUENCIES ON THE AIR COMPANION
ANCHOR AIR SYSTEM ARRANGEMENT
ANCHOR AIR: USEFUL INFORMATION
• Main unit must have built-in AIR Companion Transmitter (X-series)
• Main unit can connect to an unlimited number of AIR Receiver Companion speakers (AIR & R-series)
• AIR companion speaker can be placed 300+ ft. from the main unit
• Although AIR has volume control, the main unit volume will raise or lower AIR companion volume
• AIR Transmitter connects to Anchor Audio Assistive Listening belt pack receivers
AIR COMPANION
LIBERTY &
GO GETTER
Connect speaker cable (SC-50NL) to the SPEAKER OUT jack on the back of the
powered Liberty or Go Getter sound system. Connect the other end of the jack
to the back of an unpowered companion speaker. AC power is not required for an
unpowered companion speaker. The AIR companion can be operated on battery
power or AC power.
MEGAVOX
Connect speaker cable (SC-50) to the SPEAKER OUT jack on the back of a powered
MegaVox PA system. Connect the other end of the jack to the back of an unpowered
companion speaker. The AIR companion can be operated on battery power or AC power.
1. Connect provided external antennas to main unit and AIR companion unit.
2. Power on main unit and AIR companion.
3. Verify the AIR companion speaker is in AIR MODE by checking the AIR/WIRED toggle switch.
4. On main unit, push AIR Companion Transmitter POWER button to turn on AIR transmitter. On AIR
companion, push AIR Companion Receiver POWER button to turn on AIR receiver.
5. Adjust volume knob on back panel as needed.
NOTE: Verify both AIR Companion Transmitter and AIR Companion Receiver are synchronized to the same
channel. The default frequency setting is 902.00. This can be changed as needed.
1. Using a pointed edge tool, hold SET button for 2 seconds. Digital display will blink.
2. Press UP or DOWN to select desired frequency.
3. To confirm frequency selection, press SET button or wait 10 seconds for display to stop blinking.
1. Follow instructions to set up AIR Companion Transmitter
2. Install two AA 1.5V batteries in Assistive Listening belt pack (ALB-9000)
3. Straighten belt pack antennas for maximum reception
4. Plug in headphones to belt pack
5. Power on belt pack and adjust volume as needed.
NOTE: Verify both AIR Companion Transmitter and ALB-9000 are synchronized to the same channel. The
default frequency setting is 902.00. This can be changed as needed. Follow instructions above in Changing
Frequencies.
CONNECTING AIR TRANSMITTER TO ASSISTIVE
LISTENING BELT PACK RECEIVERS
1. Power off main unit and AIR companion speaker.
2. On the AIR companion speaker, move toggle switch to WIRED MODE.
3. Follow instructions below to connect speakers using a wired connection.
CONNECTING AIR COMPANION SPEAKER - WIRED
MICROPHONE
150 FEET MAX
300+ FEET
300+ FEET