TWO YEAR WARRANTY
Assistive Listening Owners Manual
For System Setup & Operation Videos Visit Our Website: www.anchoraudio.com
3
BELT PACK TRANSMITTER SETUP
Model: WB-6000
Belt pack transmitter for use with Anchor Audio 16 channel belt pack
receivers. The transmitter operates in the UHF band frequency and is
powered by two DC 1.5V “AA” size batteries.
BELT PACK SETUP
1.
INSERT BATTERIES:
Open battery compartment by gently push/sliding
door. Insert two “AA” batteries.
2.
SET CHANNEL:
Using the included screwdriver turn the Channel
Selection Dial to the same channel as the receiver.
NOTE: The transmitter and receiver MUST be set to the same channel to
operate correctly.
3.
CONNECT MICROPHONE:
Insert the headband microphone plug into the
jack labeled INPUT located on top of the transmitter.
4.
POWER ON:
Slide transmitter power switch to “ON”. The red LED will
flash when the mic is turned on, if the LED stays on, the batteries are low
and need to be replaced.
CHANNEL
SELECTION DIAL
BASE STATION TRANSMITTER SETUP
The Base station transmitter is for use with Anchor Audio 16 channel belt pack receivers. The transmitter
operates in the UHF band frequency on 16 channels and is
powered by an included AC power adapter.
BASE STATION SETUP
1.
CONNECT ANTENNA:
Attach the UHF antenna to
the Antenna Socket labeled RF OUT on the rear
panel.
2.
CONNECT POWER:
Plug the AC adapter into the
DC Input Jack on the rear panel. Then plug the AC
adapter into a power outlet.
3.
SETUP INPUT SOURCE:
Connect a wired micro-
phone to the Microphone Input Jack on the rear
panel. Adjust the MIC Volume Control knob on
the front panel to set level. Use the RCA Input Jack
on the rear panel to connect a stereo audio device.
Adjust the Line In Volume Control knob on the front
panel to set level.
4.
SET CHANNEL:
Press the Power button on the
front panel to turn on the transmitter. Turn the
Channel Selection Knob to the channel you chose.
NOTE: Transmitter & receiver MUST be set to the
same channel.
5.
MONITOR TRANSMISSION:
For monitoring
purposes, plug headphones into the Monitoring
Headphone Jack on the front panel. Adjust the
headphone volume with the Monitoring Headphone
Volume Control knob.
NOTE: If you experience ongoing interference with your wireless system, the selected frequency may be
incompatible with other systems in the area! Try different channels to find a clear frequency!
WIRELESS TRANSMITTER
Model: AL-TX
MICROPHONE INPUT JACK
ANTENNA SOCKET
STEREO/MONO SWITCH
RCA INPUT JACK
DC INPUT JACK
CHANNEL DISPLAY LED
CHANNEL SELECTION KNOB
MONITORING HEADPHONE JACK
PEAK INDICATOR
MONITORING HEADPHONE VOLUME CONTROL
MIC VOLUME CONTROL
POWER
LINE IN VOLUME CONTROL
NOTE: If you experience ongoing interference with your wireless system, the selected
frequency may be incompatible w/ other systems in the area!
Try different channels to find a clear frequency!
