Anbash NC238SW, Руководство по установке

Страница: 25 / 77

- 25 -
4.2
UPNP SETUP---Enabling UPnP for Automatic Remote Access Setup
Usually it is very simple to enable UPnP. You just need to log in to your router’s setup screen and find the UPnP menu.
Then you click on enable, save the setting and restart both the router and the camera (in that order).
The camera comes from the factory with the UPnP enabled. You can double check by selecting the
UPnP Setup tab
under the camera’s Network menu:
[UPnP] Enable or disable the UPnP function. We recommend you to have UPnP enabled. For most users, the rest
of the settings can be left as the default settings.
[Gateway HTTP/RTSP port forwarding] If this is enabled, the camera will automatically add a port forwarding rule
to your router via UPnP protocol.
[External HTTP/RTSP port range]
By default, this port range is 8150 – 8350. The
ports are assigned in order, so if you only have one camera attached to your system, the chosen port will be
8150(8150-8150) for the first camera, 8151 for the second(8151---8151), and so on. Every camera will remember
its port, and it will automatically use this port (if still available) whenever it is powered on.
[Gateway RTP port forwarding] Used when viewing the feed through a VLC player. If not wishing to view the
feed through a VLC this should be left enabled.
[External RTP port range] The RTP port range can't be changed here - you should change it from the TCP/IP setup
page.
Click Apply to confirm your setting.
If your router UPnP is enabled, the UPnP is still not shown as above, then power off the router and restart both the
router and camera.
If UPnP works, clicking on the camera’s “system” menu at the top of the setting screen will show something like the
following in the UPnP section: