Anatomic SITT Zitzi Sharky Pro, Руководство пользователя

Страница: 8 / 56

8 User manual Zitzi Sharky Pro www.anatomicsitt.com | +46 11 16 18 00
Installation of the backrest
The backrest attachment consists of 4 screws (A) and two rail pins�
Line up and slide down the back profile onto the rail pins on the back joint housing�
Then tighten the four screws (A) using the allen key�
The backrest is automatically positioned in the correct position through
pre-assembled stops in the back profile�
Adjusting the backrest height
To adjust backrest height, loosen the screws (B) on both sides of the back profile
using the allen key, and adjust to the desired height� When you are satisfied with
your setting, tighten the screws (B) again� Loosen the knob (E)�
Adjusting the backrest angle
Place the activation lever (C) in active position by lifting it up and then
pushing it onto the heel�
To adjust the angle of the backrest, press the lip down� The gas piston now
activates the back so you can move the back to desired position� Once you reach
the desired angle, release the activation lever again to retain your set angle�
Adjusting the lateral support
To adjust the width and height of the lateral support, loosen the finger knob (D)
and adjust to the desired height and width� Tighten the finger knob (D) when you
have reached the desired position�
Adjusting the lumbar support
Loosen the knob (E) and press the top end of the lumbar support which is
placed behind the back lining until the desired lower back depth is reached�
Hold the lumbar support in position and then tighten the knob (E)�
Backrest
Note!
Remember to always hold the back steady when you activate
the gas piston�
Note!
The backrest height might need to be adjusted for the lumbar
support to be in the correct position�
Tip!
Remove the backrest lining to ensure a better lumbar support view
during adjustment�