Analogue Solutions Telemark-k, Руководство пользователя

Страница: 19 / 22

Analogue Solution – Telemark-k – 2012
19 | P a g e
Parameters and Pages in More Detail
Page number (0-5) is displayed on the far left as a single digit. The top line shows parameter names, bottom line
show parameter value.
PAGE0
(1)RX.CHAN (2)TX.CHAN
1-16 1-16
1
2 Sets the MIDI receive channel for the internal MIDI-CV converter
Sets the MIDI transmit channel of the keyboard.
PAGE1
(3)TRANSPOSE (4)OCTAVE
000-015 000-003
3
4 Transposes the keyboard in semitones upwards.
Transposes the keyboard in 12 semitone increments (i.e. whole
Octaves)
PAGE2
(5)AUX.CC# (6)PB.RANGE
000-127 000-007
5
6
Changes the MIDI controller number for CV2 (aux.CV). 127 is used
to set velocity as the source. This setting will affect which MIDI
controller the keyboard or external MIDI will be the source for
modulating CV2 (aux.CV). The controller you set can then be used to
control whatever synth setting is set to MIDI on the front panel, for
example filter cut-off.
Pitch bend range. +/- 0-7 semitone range.
PAGE3
(7)F.TUNE (8)P.SCALET
0000-255 000-255
7
8
A very fine tune setting. This is used to trim the internal MIDI-CV
DAC. Normally there would be no need to alter this.
This alters the octave spacing for the MIDI-CV converter. This affects
the pitch/scaling of the VCOs. Normally there would be no need to
alter this.
PAGE4
(9)LOCAL (10)RE-TRIG
000-001 000-001
9
This turns on/off Local.
0= off. This means the keyboard will not play the internal voice. The
voice can only be controlled via the CV/Gate sockets or an external
MIDI device such as a sequencer.
1= on. This means the keyboard will play the internal voice.
Either way, the note that you play on the keyboard will be sent
to the MIDI Out socket.
10
This setting is not used. However, it will display the last note played!
PAGE5
STORE SETUP
PRESS +OCT TO STORE
This is the page used to store set-up, as described earlier.
RESTORING FACTORY DEFAULTS
Hold down button 8 (OCT+) whilst turning on the machine to restore factory default settings.