Analogue Solutions FUSEBOX X, Руководство пользователя

Страница: 50 / 52

Analogue Solutions | FUSEBOX X | Manual
No Signal?
There are many settings that can kill the sound!
General things-
Do you have audio going correctly into your external mixer?
Is your MIDI connected correctly?
Are you triggering the EGs correctly?
Main volume up?
Leads all OK (double check! Assume nothing)?
Do you have VCO outputs patched to Mixer inputs?
Check the following…
•
Your mixing desk / monitoring equipment is on and working correctly.
•
Check the synth is switched on and that the power adaptor is functioning
correctly. Check you are using the correct mains adaptor.
•
Check it is connected to your monitoring equipment correctly and that the cable
is not faulty.
•
Ensure the output volume is high enough.
•
Ensure FUSEBOX X mixer level controls are turned up, and that audio is
patched into the mixer.
•
Certain extreme filter settings may filter out all of the signal or produce low level
signals. Try adjusting the filter cut-off.
•
Certain extreme PW/PWM settings may cause the pulse outputs to cut-out. Try
adjusting PW/PWM as necessary.
• Ensure the VCA is correctly set.
•
Ensure EGs are being triggered.
Don’t instantly assume the synth is at fault - we have had dozens of instances where
problems turn out to be faulty and intermittent leads, incorrect settings in DAW and
audio cards, mixer busses set wrong etc. We have heard all manor of crazy and silly
mistakes.
You can always plug the VCO outputs directly into your external audio mixer (watch
levels aren’t too high!) and this will give you confidence power is OK.
You can also take audio direct out from the VCF to check the filter works!
FUSEBOX X - 8 Feb 2022
| Page 50