CAUTION!
Make sure to provide an adequate ventilation for the device. When installing it into
the rack, make sure no ventilation holes are blocked. The air intakes by the front panel
and exhausts by the back of the unit.
Make sure that the rails will pass through the back ears by the minimum of 15mm/
0,59 inch
To install the rear rack rail:
Once the unit is installed into the rack.
1. Locate the four holes on each side of the device where the screws can be put into.
2. Use four M4x10 screws to fix the rear rail on each side of the device.
3. To screw the rail to the rack, screw two screws on each side of the rail (screws not provided).
4. Install the lacing bar between the two rails using two M4x10 screws. Choose the right distance according
to the cable position.
5. If needed, use tie cables to maintain the video cables on this lacing bar.
