Evaluation Board User Guide
UG-XXX
SETTING UP THE SYSTEM FOR DATA CAPTURE
After completing the steps in the Software Installation
Procedures and Evaluation Board Hardware sections, set up the
system for data capture as follows:
1.
Allow the
Found New Hardware Wizard
to run after the
board is plugged into your PC. (If you
are using Windows XP, you may need to search for the
drivers. Choose to automatically search
for the drivers for the
by the operating system.)
2.
Check that the board is connecting to the PC correctly
using the
Device Manager
of the PC.
a.
Access the
Device Manager
as follows:
i.
Right-click
My Computer
and then click
Manage
.
ii.
A dialog box appears asking for permission to
allow the program to make changes to your
computer. Click
Yes
.
iii.
The
Computer Management
box appears. Click
Device Manager
from the list of
System Tools
b.
The
board should appear under
ADI Development Tools
. This indicates that the
driver software is installed and that the board is
connecting to the PC correctly.
Figure 14. Device Manager:
Checking That the Board Is Connected to the PC Correctly
Launching the Software
After completing the steps in the Setting Up the System for Data
Capture section, launch the AD7124-8 software as follows:
1.
From the
Start
menu, select
Programs
>
Analog Devices
>
AD7124-8
>
AD7124-8 Evaluation Board Software
.
The main window of the software then displays.
2.
If the AD7124-8 evaluation system is not connected to the
USB port via the
when the software is
launched, a connectivity error displays (see Figure 15).
Connect the evaluation board to the USB port of the PC,
wait a few seconds, click
Rescan
, and then follow the on-
screen instructions.
Figure 15. Connectivity Error Alert
When the software starts running, it searches for hardware
connected to the PC. A dialog box indicates when the generic
SDP attached to the PC is detected, and then the main window
appears (see Figure 16).
Rev. PrA | Page 11 of 36
Содержание UG Series
