UG-161
EV-ADF411XSD1Z User Guide
Rev. A | Page 14 of 28
EVALUATION BOARD SOFTWARE
INT-N PLL SOFTWARE
The control software for the EV-ADF411XSD1Z is provided on
the CD included in the evaluation board kit. To install the
software, see the Installing the Int-N PLL Software section.
To run the software, click the
ADI PLL Int-N
file on the
desktop or in the
Start
menu.
On the
Select Device and Connection
tab, choose the device
and connection method, and then click
Connect.
Confirm that
SDP board connected
is displayed at the bottom
left of the window (see Figure 31). If this message is not displayed,
the software cannot connect to the evaluation board.
Note that when the SDP board is connected, there is about a
5 sec to 10 sec delay before the status label changes.
From the
File
menu, the current settings can be saved to and
loaded from a text file.
Figure 31. Int-N PLL Software, Main Window—Select Device and Connection
09146-
017
Содержание EV-ADF411XSD1Z
