EVAL-ADSW4000KTZ
User Guide
UG-1892
Rev. 0 | Page 3 of 7
HARDWARE
POWER SUPPLIES
The ADI EagleEye™ trial kit is equipped with a wide voltage
range power management circuit, which allows for the
following power supply options:
•
Micro USB (~1 m cable length). An active USB extension is
recommended when using cables longer than 1 m.
•
DC connector (5.5 V to 36 V dc).
INSTALLATION OF THE SENSOR
Mount the sensor on the ceiling at the center of the room or
region of interest (ROI) and remove the lens cap (if present).
The lens of the device must face down and cover the entire
room or ROI, including the corners of the space. Users can check
for the proper installation of the sensor and the field of view
(FOV) during the commissioning process in the ADI EagleEye™
PeopleCount tablet app, as described in the Commissioning
section.
Installation Height
The recommended installation height for the sensor is between
2.44 m and 3.00 m (8 ft and 10 ft).
Sensor Mounting: Horizontal
Ensure that the sensor is mounted horizontally at an angle of
90° to the floor (see Figure 2).
25189-
002
Figure 2 Improper (Top) and Proper (Bottom) Alignment of the Sensor
Parallel to the Floor Area
Sensor Mounting: Axis
Ensure that the longer dimension in the ROI corresponds to the
x-axis of the camera module to maximize the FOV, as shown in
Figure 3.
25189-
003
Figure 3. Improper (Top) and Proper (Bottom) Alignment of the Sensor to
Maximize the FOV
Sensor Mounting: Alignment
Ensure that the sensor is mounted parallel to the borders of the
room and is not rotated. If the sensor is properly aligned, the
walls appear symmetric at the center of the captured image
(see Figure 4).
25189-
004
Figure 4. Improper (Top) and Proper (Bottom) Alignment of the Sensor
Parallel to the Walls
Downloaded from
Downloaded from
Downloaded from
