
10
Rev. 0
DC1941 TO DC2515 REVERSE isoSPI CONNECTION
A reverse isoSPI connection begins with the isoSPI mas-
ter connected to the last (or “top”) DC2515. Additional
DC2515 boards can be daisy-chained onto the isoSPI bus.
Communication begins from the last (or “top”) DC2515
then to the next “lower” DC2515 and, finally, to the first
(or “bottom”) DC2515.
Figure 8 shows the following connections for two boards
on a stack interfaced to a PC:
1. Connect a USB cable from the PC USB port to the
DC2026 J5 connector.
2. Connect the DC2026 to the DC1941 isoSPI demo board.
a. Connect a 14-pin ribbon cable from the DC2026 J1
header to the DC1941 J2 header.
3. Refer to the DC1941 isoSPI Master Settings section of
this demo manual to properly setup the DC1941.
4. Connect the DC1941 to the DC2515 in isoSPI mode.
This DC2515 is the last (or “top”) board of a two-board
stack.
a. Connect a RJ45 patch cable from the DC1941 J1
RJ45 connector to the “top” DC2515 J1 isoSPI B
RJ45 connector.
b. Set the “top” DC2515 JP1, JP2, and JP4 to 1 for
isoSPI communication.
c. JP3 can be 0 or 1 depending if the Discharge Timer
function is being used.
5. Connect or daisy-chain the DC2515 to another DC2515
in isoSPI mode. This DC2515 is the first (or “bottom”)
board of a two-board stack. More DC2515 “lower”
boards can be daisy-chained together in the same
manner.
a. Connect a RJ45 patch cable from the “top” DC2515
J2 isoSPI A RJ45 connector to the next “lower” or
“bottom” DC2515 J1 isoSPI B RJ45 connector.
b. Set the next “lower” or “bottom” DC2515 JP1, JP2,
and JP4 to 1 for isoSPI communication.
6. CAUTION! Prevent damage to the DC2515. Refer to
Table 1 and confirm that the cell-voltage connections to
the screw-terminal block matches the DC2515 J3 pinout.
a. Plug the screw-terminal blocks into the J3 cell-
voltage connectors.
7. Refer to the Software Setup section of this demo manual
to properly setup the PC with the Arduino IDE software
to allow communication to the DC2515 boards.
Figure 8. DC1941 Reverse isoSPI Connection to the “Top” DC2515 in a Two-Board DC2515 Stack
DC2026
DC2515
USB
1
0
1
0
1
0
1
0
DTEN
ISOMD
JP4
JP3
JP2
JP1
isoSPI A
J2
J4
J5
J1
DC1941
J2
J1
isoSPI B
J1
J3
DC2515
DTEN
ISOMD
JP4
JP3
JP2
JP1
isoSPI A
J2
J4
isoSPI B
J1
J3
DC2515 F08