Table 3-5:
Output Signals of Microchip GPIO Expander (U48 Port B) (Continued)
Bit
Signal Name
Description
FET
Processor Signal
(if applicable)
Connected
Default
7
SPDIF_
DIGITAL_EN
Enables S/PDIF digital connec-
tors
U11 and
U12
DAI0_PIN09, DAI0_PIN10
J11
High
Tables
Output Signals of Microchip GPIO Expander (U48 Port A)
and
Signals of Microchip GPIO Expander (U48
Port B)
show the output signals of the Microchip GPIO expander (
U48
), with a TWI address of
0100 010X
,
where
X
represents the read or write bit. The signals that control an individual FET have an entry in the
FET
col-
umn. The
Component Connected
column shows the board IC that is connected if the FET is enabled. However, in
most cases, the Microchip (
U48
) is controlling the enable signal of a FET switch. Also note that if a particular func-
tionality of the processor signal is being used, it is in
bold
font in the
Processor Signal
column.
Table 3-6:
Output Signals of Microchip GPIO Expander (U48 Port A)
Bit
Signal Name
Description
FET
Processor Signal
(if applicable)
Connected
Default
0
NOT USED
1
PUSHBUTTON2
_EN
PC_07 is used as GPIO input
for push button 2, enabled by
default
U15
PC_07/LP1_CLK/
OSPI_SEL4b/TM0_TMR9/
SYS_FAULT
SW3
Low
2
PUSHBUTTON1
_EN
PB_03 is used as GPIO input for
push button 1, enabled by de-
fault
U14
PB_03/TM0_TMR3/FLG2/
SPI2_SEL2b/SMC0_ADDR1/
CNT0_UD
SW4
Low
3
LEDS_EN
Px & DAI is used as GPIO out-
put for LED7,9,10 enabled by
default
U8
DAI0_PINI08, DAI0_PIN11,
PB_03
LED7,9,10
Low
4
NOT USED
5
NOT USED
6
NOT USED
7
NOT USED
Table 3-7:
Output Signals of Microchip GPIO Expander (U48 Port B)
Bit
Signal Name
Description
FET
Processor Signal
(if applicable)
Connected
Default
0
ADAU1977_EN
Enables ADAU1977
U8
DAI0_PIN08, DAI0_PIN09,
DAI0_PIN11 and DAI0_PIN19
U44
High
1
ADAU1977_
FAULT_RST_
EN
Enables ADAU1977 FAULT and
RESET
U7
PB_13/LP0_D6/SPI1_SEL3b/
UART2_RTSb and ADAU_RE-
SET
U44
High
Software-Controlled Switches (SoftConfig)
ADZS-21569-EZKIT
Manual
3–9
Содержание ADZS-21569-EZKIT
Страница 36: ...ADZS 21569 EZKIT Manual 20...