ADXRS450 - UG
Evaluation Board User Guide
Rev. 0 | Page 6 of 17
Installing the ADXRS450 Software Evaluation GUI
The software GUI installation has been created to include any
required National Instruments drivers and run-time engines
which are necessary for proper operation. In order to run the
software GUI installation routine, double click on the
“setup.exe” file located in the /
ADXRS450 Evaluation
Software
/ folder on the included CD. The user will be greeted
with the following screen:
Figure 11: ADXRS450 evaluation software installation welcome screen
From this point, the following steps should be completed in
order to successfully install the evaluation software.
1.
Select the destination directory
. The installer will auto-
populate the directory names where it would like to store
the software GUI and required National Instruments
products (Figure 6). These directories can be changed by
the user, if desired, however most installations can proceed
with the default values. Click Next.
2.
License Agreement
. Once the installation directories have
been chosen, the user will be prompted with the National
Instruments Software License Agreement. It is highly
recommended that the user read this agreement before
accepting, and clicking the Next button.
3.
Start Installation
. The installer will then list the required
components which need to be installed on the user’s PC
(Figure 7). Click Next.
4.
Installation Complete
. The installer will now complete
the installation of the software evaluation GUI and all
required National Instruments drivers and run-time
engines. After the installation is complete, the user will see
the screen shown in Figure 8. Click Finish to complete the
installation.
Figure 12: Destination Directory Selection
Figure 13: Start Installation screen (Note: depending on the requirements of
each PC, the components listed above may be different)
Figure 14: Installation Complete!
