UG-668
EVAL-ADuCM350EBZ User Guide
Rev. A | Page 4 of 28
GETTING STARTED
SOFTWARE INSTALLATION PROCEDURES
For software installation procedures, refer to the following
ADuCM350
software documentation for further details:
•
For more information about the EKSP LabVIEW® GUI,
refer to the EKSP user guide (
ADuCM350_Evaluation_Kit_
Software_Platform.pdf
) within the
Documentation
folder of the software development kit.
•
For more information about the SDK firmware/debug
environment, refer to SDK user guide (
ADuCM350BBCZ_
Software_Users_Guide.pdf
) within the
Documentation
folder of the software development kit and to the
ADuCM350
software development kit quick start guide,
UG-677
.
EVALUATION BOARD SETUP PROCEDURES
1.
Plug the
ADuCM350
switch mux configuration board into
the
ADuCM350
evaluation board,
EVAL-ADuCM350EBZ
.
2.
Plug the USB-SWD/UART-EMUZ board into J14 on the
ADuCM350
evaluation board,
EVAL-ADuCM350EBZ
.
3.
Plug the USB cable into the USB-SWD/UART-EMUZ board.
After the drivers are downloaded, you can begin communicating
with the board.
Figure 2.
EVAL-ADuCM350EBZ
Setup
12104-
003