Analog Devices ADSP-21479 EZ-Board, Руководство пользователя

Страница: 42 / 113

UART Interface
1-22 ADSP-21479 EZ-Board Evaluation System Manual
the analog audio interface. Switch
SW23
must be enabled for the head-
phones. A volume control potentiometer (
R493
) is used to increase or
decrease the headphone’s volume. For more information, see “Headphone
Enable Switch (SW23)” on page 2-18.
Example programs are included in the EZ-Board installation directory to
demonstrate how to configure and use the board’s analog audio interface.
The DAI and DPI pins going to the AD1939 device can be disabled, then
used again on the expansion II interface. Refer to
“DAI Interface” on
page 2-3 and “DPI Interface” on page 2-4 for more information about the
DAI and DPI switches.
UART Interface
The ADSP-21479 processor features a built-in universal asynchronous
receiver and transmitter (UART). The UART interface supports full
RS-232 functionality via the Analog Devices 3.3V ADM3202 line driver
and receiver (
U8
). The UART signals are available on the EZ-Board via a
DIP switch (
SW14
). The UART signals routed through the DIP switch can
be disconnected from the respective DPI interface and used on the expan-
sion II interface. The following DPI pins are used for the RS-232
interface.
• DPI pin 9 (
DPI_P9
) as
UART_TX
• DPI pin 10 (
DPI_P10
) as
UART_RX
• DPI pin 11 (
DPI_P11
) as
UART_RTS
• DPI pin 12 (
DPI_P12
) as
UART_CTS