ADSP-21992 EZ-KIT Lite Evaluation System Manual
2-23
Figure 2-21: Completing Driver Installation Dialog Box
13.
Click
Finish
to exit the wizard.
14.
Verify the installation by following the instructions in section
2.4.5 Driver Installation Verification
Before you use the EZ-KIT Lite evaluation system, verify that the USB driver software is
installed properly:
1.
Ensure that the USB cable is connected to the evaluation board and the PC.
2.
Press the
RESET
button (S1) on the evaluation board.
3.
Verify that the red USB monitor LED (CR7) is lit. This signifies that the board is
communicating properly with the host PC, and is ready to run Vi+.
2.4.6 Starting Vi+
In order to start debugging, you must set up a session in Vi+.
1.
Hold down the
Control
(CTRL) key.
2.
Click the
Start
button on the Windows taskbar, and then choose
Programs
,
VisualDSP,
Vi+ for 21xx
.
The
Session List
dialog box appears if you already have existing sessions. Skip to step 4 if this is
the first time running Vi+.
