ADSP-21992 EZ-KIT Lite Evaluation System Manual
2-7
The EZ-KIT Lite evaluation board contains ESD (electrostatic
discharge) sensitive devices. Electrostatic charges readily
accumulate on the human body and equipment and can
discharge without detection. Permanent damage may occur on
devices subjected to high-energy discharges. Proper ESD
precautions are recommended to avoid performance degradation
or loss of functionality. Store used EZ-KIT Lite boards in the
protective shipping package.
2.3 PC
Configuration
For correct operation of the Vi+ software and the EZ-KIT Lite evaluation system, your
computer must have the minimal configuration shown in Table 2-1.
Table 2-1: Minimum PC Configuration
Windows
98, Windows 2000, Windows XP
Intel (or comparable) 166MHz processor
VGA Monitor and color video card
2-button mouse
50MB free on hard drive
32 MB RAM
Full-speed USB port
CD-ROM Drive
!
Note: This EZ-KIT Lite does not run under Windows 95 or Windows NT.
2.4 Installation
Tasks
The following tasks are provided for the safe and effective use of the ADSP-21992 EZ-KIT Lite.
Follow these instructions in the order presented to ensure correct operation of your software and
hardware. Perform the following tasks to install the ADSP-21992 evaluation system.
1.
Install Vi+ software and EZ-KIT Lite debug software
2.
Install Vi+ license
3.
Set up EZ-KIT Lite hardware
4.
Install EZ-KIT Lite USB driver
5.
Verify the USB driver installation
6.
Start Vi+
2.4.1 Install the Vi+ Software
This EZ-KIT Lite comes with the latest version of Vi+ for the ADSP-219x and ADSP-
2199x DSP families.
1.
Insert the Vi+ CD-ROM into the CD-ROM drive.
2.
If Auto Run is enabled on your PC, the home screen of the Vi+ install wizard
will appear. Otherwise, choose
Run
from the
Start
menu, and enter
D:\Setup.exe
in the
