AD9643/AD9613/AD6649/AD6643 User Guide
UG-293
Rev. A | Page 5 of 26
Switching Power Supply
Optionally, the ADC on the board can be configured to use the
ADP2114
dual switching power supply to provide power to the
DRVDD and AVDD rails of the ADC. To configure the board
to operate from the
ADP2114
, incorporate the following changes
(see the Evaluation Board Schematics and Artwork and the Bill of
Materials sections for specific recommendations for device values):
1.
Install R204 and R221 to enable the
ADP2114
.
2.
Install R216 and R218.
3.
Install L201 and L202.
4.
Remove JP201 and JP203.
5.
Remove jumpers from across Pin 1 and Pin 2 on P107 and
P108, respectively.
6.
Place jumpers across Pin 1 and Pin 2 of P106 and P109,
respectively.
Making these changes enables the switching converter to power
the ADC. Using the switching converter as the ADC power
source is more efficient than using the default LDO regulators.
