Evaluation Board User Guide
UG-232
Rev. 0 | Page 7 of 32
09
57
2-
0
07
COLLAPSE DISPLAY
Figure 7. VisualAnalog – [Canvas – (AD6657 FFT)*], Main Window
Setting Up the SPI Controller Software
After the ADC data capture board setup is complete, set up the
SPIController
software using the following procedure:
1.
Open the SPI controller software by going to the
Start
menu
or by double-clicking the
SPIController
software desktop
icon. If prompted for a configuration file, select the appropriate
one. If not, check the title bar of the window to determine
which configuration is loaded. If necessary, choose
Cfg
Open
from the
File
menu and select the appropriate file
based on your part type. Note that the
CHIP ID(1)
field
should be filled to indicate whether the correct SPI
controller configuration file is loaded (see Figure 8).
09
57
2-
0
08
Figure 8. SPIController, CHIP ID(1) Box
Содержание AD6642
