P a g e
|
3
Software Installation
To install Analog Arts application software, please visit:
http://www.analogarts.com/downloads/demo-application-software
.
Specifications
To review the frequency & phase analyzer specifications, please visit:
http://www.analogarts.com/images/AnalogArts/PDFs/Scope-%20Spectrum%20Analyzer-
%20Data%20Recorder%20Specifications.pdf
Handling Precautions
Please observe the following precautions while handling your instrument:
1- Do not use this instrument immediately after bringing it from an extremely hot or cold
place.
2- Do not expose the instrument to wet or very dusty environments.
3- Do not place liquid-filled containers close to this instrument.
4- Do not use this instrument in strong magnetic fields.
5- Do not apply the instrument to voltages exceeding the maximum rating.
Operation Instruction
This section contains the required information to operate Analog Arts frequency & phase
analyzer and reviews its associated options.
Front & Back Panel Items
The following diagram shows the position of CH1 (channel 1 input,) CH2 (channel 2
input,) TRIG (oscilloscope trigger,) and USB connector locations on the panels of a
typical frequency analyzer unit.
1- CH1 input of the frequency analyzer; often connected via a probe or coaxial cable to the
source input.
2- CH2 input of the frequency analyzer; often connected via a probe or coaxial cable to the
source input.
3- Trigger (synchronize) input of the instrument, not applicable for this instrument.
4- Data transfer LED
5- On/ Off LED
6- USB connector; connected via a USB cable to the computer
