10
Your
Advanced Laser Comb
comes with four AA batteries already
installed. To use the Laser Comb, you must remove the cardboard
protective strip located in the battery compartment. Follow these steps:
1.
Verify the model of your device located on the handle.
If you
purchased a Professional Laser Comb, refer to pages 16-23 of
the User Manual.
2. Remove the blue label on the bottom of the Laser Comb.
3. Using a thin coin or your finger
nail, depress the Battery Cover
Tab (see Figure A) and remove
battery door.
4. Open the battery compartment.
5. Locate and remove the
cardboard protective strip
(Figure B).
6. Replace Battery Cover by aligning
bottom of Cover in grooves and
then pressing the top of Cover until
it snaps into place.
7. Your Laser Comb is now ready for use.
Replacing Batteries
The Laser Comb is designed to provide the optimum laser output
even as the batteries age. When the batteries weaken to the point
where they will no longer power the lasers to their optimum power
level, the green battery indicator will flash from green to red and
the lasers will flash.
This is an indication that the batteries need to be replaced. Use the
following steps to replace the batteries.
GETTING STARTED – FOLIGAIN.L7x
®
ADVANCED LASER COMB • REPLACING BATTERIES
THIS SECTION APPLIES TO FOLIGAIN.L7x
®
ADVANCED LASER COMB MODEL ONLY
For FOLIGAIN.L12x
®
Professional Laser Combs refer to pages 16-23 for instructions
BATTERY
COVER TAB
REMOVEABLE CARDBOARD STRIP
