AMX PTE-300, Руководство по эксплуатации/справочник, Страница: 16 / 44

Installation
12 PTE-300 PosiTrack Ethernet Camera Controller
4.
Place the assembly on a balancing beam and, while maintaining the cradle centered on the pipe,
slide the camera along the cradle’s grooves until the camera and cradle remain balanced on the
beam (see FIG. 16). Verify the balance with a spirit level.
5.
Mount the camera as close to the Tilt Hub as possible to obtain a true center of gravity. The center of
gravity is the location on the long axis of the camera/lens assembly around which the camera and
mount balances.
6.
Re-attach the camera mount (with camera/lens) to the cradle support bracket using the two 1/2”
screws.
7. Take the entire camera/mount and cradle assembly and align the lens with the Tilt Hub so that the
vertical axis intersects the center of the camera’s iris, as shown in FIG. 17.
8.
Mark the position of the cradle support bracket on the Tilt Hub (for later attachment).
9.
Remove the camera/lens and mount piece from the support bracket by unscrewing the two 1/2”
screws on the underside of the camera mount.
10.
Secure the support bracket to the Tilt Hub (at the same position marked for the iris alignment) on the
PTE-300 with some or all of the four 1/2” screws and washers.
11.
Secure the camera/mount to the support bracket by using the two 1/2” screws.
12.
Support the weight of the camera cables with a wire tie attached to the wire tie mount on the lower
corner of the face of the PTE-300 (FIG. 13).
FIG. 16
Balancing the camera/lens cradle assembly
FIG. 17 Iris alignment with vertical tilt-axis
cradle
(bottom view)
balancing beam
Marker points
Iris
Vertical tilt-axis
The camera/lens cradle can be mounted on either side of the cradle support bracket.