AMX PT10-PLV, Инструкция по эксплуатации, Страница: 9 / 32

Installation and Wiring
5
PT10-PLV Single Camera Pan/Tilt System
Installation and Wiring
This section covers the steps necessary to connect and operate a PT10-PLV Single Camera Pan/Tilt
System. Digital encoders are installed on both the pan and tilt drives, allowing positional feedback
for presets, and to provide accurate speed control. Software adjustable stop limits are used to limit
the range of motion. Before continuing, verify that you have received the correct components for
your package. Refer to the PT10-PLV System Components section on page 1 for more information.
Preparing the AXB-PT10 for Communication
If you add one or more AXB-PT10s to your system, it will be necessary to set the AXlink Device
DIP switches on the additional PT10s. The AXB-PT10 that came with your kit was factory set as
AXlink device number 90. The first additional AXB-PT10 must be set to AXlink device 91, the
next one to device 92, and so on - up to 95 (for a maximum total of six PT10s).
The AXlink Device DIP switch is located beneath the round cover on the back of the AXB-PT10.
FIG. 2 shows the location of the DIP switch and each of the possible AXlink Device DIP switch
settings for additional AXB-PT10s.
Mounting the AXB-PT10
Mount the AXB-PT10 to a flat horizontal surface, either upright or inverted.
1.
Select a surface that can support the combined weight of the AXB-PT10 (8.00 lbs./3.63 kg),
camera/lens (10 lbs./4.54 kg), and control cables. Some support surfaces include the WM-
CAM, PM-CAM, and TM-CAM mounts available for use with these units.
2. Locate the external white position markers located on the pan and tilt axis. The position
markers must align with the pan and tilt axis in order to be considered in the home position.
FIG. 3 shows the camera cradle attachment in the center position.
FIG. 2 AXB-PT10 (rear view) and AXLink Device DIP switch settings for devices 90 - 95.
AXlink Device
DIP switch
Device #90
(base AXB-PT10)
Device #93
Device #94
Device #95
Device #91
Device #92
Do not mount a PosiTrack unit in any location where the motion of the camera is obstructed by any
object, or handle or lift the AXB-PT10 by the camera cradle. Doing so may damage internal
components.