For full warranty information, refer to the AMX Instruction Manual(s) associated with your Product(s).
9/10
©2010 AMX. All rights reserved. AMX and the AMX logo are registered trademarks of AMX.
AMX reserves the right to alter specifications without notice at any time.
3000 RESEARCH DRIVE, RICHARDSON, TX 75082 • 800.222.0193 • fax 469.624.7153 • technical support 800.932.6993 • www.amx.com
93-2255-05
REV: D
Attaching the Modero Panel to the NXT-BASE/1
ATTENTION!
The battery base CANNOT be hot-swapped. An NXT can not be receiving
power (through a connected power supply) and then be connected to a battery
base. Always POWER OFF the panel before installing the NXA-BASE/1.
1.
Power Off the panel before attempting to attach the NXA-BASE/1.
2.
Place the battery base (with battery) onto a flat/level surface.
3.
Turn the battery locking slider (see FIG. 1) to one side until the locking
mechanism is horizontal to the base (going left to right) and the rear battery
latch is pointing directly outward (away from the LCD).
4.
Carefully angle the panel over the front alignment pegs (FIG. 3). The pegs
assist in both aligning and securing the panel to the base (the locking
mechanism secures the base to panel when done).
5.
Insert the alignment pegs into their corresponding holes below the front of
the panel.
6.
Verify the alignment of the Panel Interface connectors between the panel
(female connector) and base (male connector) (FIG. 3).
7.
Align the rear pegs and gently push the rear of the panel downwards until it
is mounted atop the battery base.
8.
Slide the rear battery locking slider in the opposite direction. This turns the
latching mechanism and secures the panel to the base.
9.
Upon successful connection, the AMX logo appears on the panel to indi-
cate that the panel is properly connected and receiving power.
Charging the NXT-BP using the NXA-BASE/1
1.
Insert the battery into the battery compartment (FIG. 2).
2.
Follow the procedures from the previous sub-section to attach the panel to
the NXA-BASE/1.
3.
Insert a 2-pin connector from a power supply to the rear PWR connector
on the panel.
Attaching the Rubber Feet to the NXA-BASE/1
The NXA-BASE/1 comes with four rubber feet that can be attached to the
bottom of the unit. Also provided with the NXA-BASE/1 is a Rubber Foot
Placement Template.
Use the Placement Template to position the Rubber Feet on the bottom panel.
Note
: Prep the surface area with alcohol prior to installing feet.
FIG. 3
NXA-BASE/1 shown aligning with an NXT-CV7 panel
Alignment pegs
Battery Lock
