Encoder Configuration Options
43
N2412A/N2422A User Manual
AES67 Page
Click the
AES67
link at the top of any of the main web pages to access the page shown in
.. Options are described in
. AES67 is an open standard for audio over IP and audio over Ethernet. This page allows you to configure the Encoder to
generate AES67 audio and send it to devices that support it.
FIG. 39
AES67 Page
Port
This field should always be set to
1319
.
Device Number
Defaults to a dynamic device number. May be set to a static range (e.g., 8000).
System Number
Determines which system to connect. This setting is dependent upon the
Master Mode
selected (see above).
• If
Master Mode
is set to
Auto
, the
System Number
is set and the system discovers the Master Controller’s IP
address.
• If
Master Mode
is set to
Listen
, the device connects to any Master Controller.
• If
Master Mode
is set to
URL
, the IP of the Master Controller is set.
Username
Username for the Master Controller.
Password
Password for the Master Controller.
Save button
Click to save settings made on this page.
TABLE 17
NetLinx Page Options (Cont.)
Command
Description
TABLE 18
AES67 Page Options
Command
Description
AES67 Audio
Enable to turn on AES67 audio and turn off other audio streams.
AES67 Audio Address
Enter the IP address of the destination device. The address’s first octet must start with 239 (e.g.,
239.xxx.xxx.xxx). It will not work with other numbers for the first octet.
AES67 Audio Port
Enter the port number of the destination device.
Save button
Click to save settings made on this page.