Encoder Configuration Options
29
N2412A/N2422A User Manual
RS232 Settings
The section of the
Settings
is displayed when you click the
RS232 Settings
link. Options are described in
FIG. 21
RS232 Settings
Effects Settings
The section of the
Settings
page shown in
is displayed when you click the
Effects Settings
link. Options are described in
.
FIG. 22
Effects Settings
IR Repeat Holdoff
Set the repeat delay between IR commands. The default
setting is 90 ms.
This is the amount of time before a new command is
sent. For example, when pressing and holding the
volume button on a remote control, this is how long
until the command is repeated.
Relaxed Analog Input
Timing
Enable to allow small variances in the analog input (to
avoid video interruption).
Interleaved Multicast
Streams
Enables a multicast format which interleaves video and
audio streams.
In order for N-Series devices to communicate with
each other, their multicast settings must be
compatible.
Low Power Mode
Enable to enable low power mode and disable all video
and audio.
When enabled, the unit draws less power and
produces less heat. It also comes back up much
quicker than a full power down. Must be disabled for
the unit to work again.
TABLE 2
Settings Page: Advanced Settings (Cont.)
Option
Description
Notes
TABLE 3
Settings Page: RS232 Settings
Option
Description
RS232 Baud Rate
Select the appropriate baud rate for the RS232 serial interface. Default is 9600.
RS232 Data Bits
Select the appropriate data bit count for the RS232 serial interface. Default is 8.
RS232 Parity
Select the appropriate parity for the RS232 serial interface. Default is no parity (
none
).
RS232 Stop Bits
Select the appropriate number of stop bits for the RS232 serial interface. Default is 1.
TABLE 4
Settings Page: Effects Settings
Option
Description
Border Enable
Enable to add a border around the video. This can help identify the video associated with a specific device.
Border Size
Adjust the border size (in pixels).
Border Color
Set a color for the border.