AMX Corporation reserves the right to alter specifications without notice at any time.
For full warranty information, refer to the AMX Instruction Manual(s) associated with your Product(s).
036-004-2786 12/05 ©2005
AMX Corporation. All rights reserved. The AMX logo is a trademark of AMX Corporation. AMX reserves the right to alter specifications without notice at any time.
3000 RESEARCH DRIVE, RICHARDSON, TX 75082 • 800.222.0193 • fax 469.624.7153 • technical support 800.932.6993 • www.amx.com
93-0031-50
REV: C
Caution:
Verify that the Strain Relief Grommet is securely closed over the
cables and the clip is facing the correct direction (upwards). The process
of securing the strain relief grommet may require the use of pliers. Also
verify the length and location of the inserted cables. once the strain relief
grommet is closed, it is difficult to re-open.
4.
Carefully apply pressure to close the strain relief grommet over the
desired cable location.
5.
Firmly push the strain relief grommet into the opening (toward the
inside) until the rim is securely flush against the back of the rear
plastic cover (FIG. 4).
6.
Securely grasp both sides of the NXD panel (with LCD, MB-TP12
back box, and attached cables), rotate the entire unit over, and lie it
on a flat level surface.
7.
Note the available mounting contact surface area on the rear plastic
cover (FIG. 3). This area represents the space available for use with
a VESA connector plate.
8.
Insert and secure the twelve #6-32 securing screws into their
pre-drilled holes along the edges of the NXD unit (FIG. 4). This step
secures the NXD unit to the rim of the rear plastic cover.
9.
Align a VESA mount connector (purchased separately) to the four
#8-32 screw holes on the back of the rear plastic cover (FIG. 4).
10. Insert the four provided #8-32 screws through the VESA mount’s four
holes and then into the pre-drilled holes on the rear plastic cover.
Note:
When installing a VESA mount to the rear plastic cover, use only
the AMX provided #8-32 screws.
Note:
When installing a VESA mount to the rear plastic cover, use only
the AMX provided #8-32 screws.
11. Secure these four #8-32 screws to the rear plastic cover by using a
grounded Phillips-head screwdriver. This step secures the VESA
mount to the rear of the panel.
Refer to your particular VESA mount manufacturer’s installation
procedures for further surface mounting procedures.
FIG. 3
MB-TP12 Mounting contact surface area
2.61[66MM]
.80[20MM]
3.55[90MM]
2.52[64MM]
FIG. 4
Location of the attachment screws on the NXD back box
Route cabling
through the
Strain Relief
Grommet
Four (#8-32) screws
Internal panel casing
MB-TP12 back box
Twelve
Rear plastic cover
(60-0031-50)
Connector
Four (pan-head) Housing Screws
Securing
(62-0031-50)
Strain relief grommet
(Clip facing up)
Rim of the strain relief grommet
should lie flush against enclosure
Opening
hole locations
(3 on each side)
securing
DO NOT REMOVE
screws
#6-32