AMX Epica DGX 144, Инструкция по эксплуатации

Страница: 40 / 107

Installation and Setup
36 Epica DGX 144 Instruction Manual
Attaching Inputs and Outputs
Input and output connectors are the attachment points for source and destination devices that connect to
the system. Epica DGX 144 enclosures have 18 vertical board slots (9 slots each for the input and the
output boards with 16 channels per board), allowing for a maximum configuration of 144x144. Viewed
from the rear of the enclosure, the input boards (for attaching sources) are on the left, and the output
boards (for attaching destinations) are on the right.
Connectors and Input and Output Channels
Epica DGX 144 board types, their connector types, and the number of available input and output
channels per board are listed in the table below.
* DMS-59 connectors are numbered for two breakout channels each.
Because some connectors are capable of routing multiple input or output
channels, the channels are numbered rather than the connectors. The input or
output channel numbers are to the left of the connectors and read from top to
bottom. Numbering is consecutive for inputs; outputs start over at 1 and
follow the same pattern. Boards are allocated 16 channels each.
For board connector information and specifications, see the specific board chapter in this manual:
SC Single Fiber input and output boards – see page 45
HD-15 RGBHV input board – see page 51
DVI input and output boards – see page 59
Board/Signal Type # and Type of Connectors # Input and Output
Channels
SC Fiber
16 SC Fiber 16 (input and output)
DVI / DVI-D
8 DVI-I
4 DMS-59* 8 (input and output)
8 (input and output)
RGBHV 16 HD-15 16 (input only)
FIG. 17
Numbers indicate input or output channels