Initial Configuration
15
NetLinx Integrated Controllers (Firmware v4)- WebConsole & Programming Guide
4.
Select
NetLinx Master
under
Platform Selection
to indicate you are working with a NetLinx Master.
5.
Select the
Serial
tab
to view the serial options (FIG. 5).
6.
On the Serial tab, set the COM port parameters (used to communicate to the NetLinx Master).
Default serial settings for NetLinx Masters are:
7.
Click
OK
to close the
Communication Settings
dialog.
8.
Note that the serial configuration is indicated in the
Configuration
text field (FIG. 6):
FIG. 4
Communication Settings dialog - Recent tab
FIG. 5
Communications Settings dialog - Serial tab
• Comm Port:
COM 1
• Baud Rate:
38400
• Data Bits:
8
• Parity:
None
• Stop Bits:
1
• Flow Control: None