Instruction Manual - Display Control and EDID Manager
Installation & Wiring
11
Installation
Warning: Before installation, ensure the device is disconnected from the power source.
1.
Position and install the mounting brackets with the four mounting screws provided.
2.
Mount and secure the device to a surface or a suitable location with the mounting screws.
Wiring
Warning: Before wiring, disconnect the power from all devices. Connect and disconnect the cables with care
1.
Connect HDMI IN
Connect an HDMI source (PC, Blu-ray player, etc.) device to HDMI IN of the DCE-1 using a high-quality HDMI cable
2.
Connect HDMI OUT
Connect an HDMI display device (LED Display, Projector, etc.) to HDMI OUT of the DCE-1
3.
Connect S/PDIF OUT and AUDIO OUT
Connect audio devices (Amplifier, etc.) to the S/PDIF OUT and AUDIO OUT port of the DCE-1
4.
Connect RS232-enabled display control
Connect an RS232-enabled display (Projector, etc.) to the RS232 port of the DCE-1 to control the display through pre-loaded
RS232 commands.
5.
Connect for relay control
Connect the projection screen to Relay 1 and Relay 2 of the DCE-1 to turn ON or OFF the screen through pre-loaded RS232
commands.
6.
Connect the included 12V power adapter to the DCE-1. Power ON all attached devices.
Attach the brackets provided to side
panels of the device
