AMX AXP-CPI16, Руководство пользователя

Страница: 13 / 18

Programming
9 AXP-CPI16 16-Channel Custom Panel Interface
Programming
Use the same Axcess commands as with other AXlink control panels, such as the AXU-MSP series
mini-softwire panels. When using the AXP-CPI16 as a control device, use On, Off, and Pulse commands
to control sources connected to outputs and Push and Release commands to receive inputs. For
additional information, refer to the
Axcess Programming Language instruction manual.
The AXP-CPI16 uses input channels to report user input on the contacts or switches attached to the input
terminals. Output channels are used to turn on the lamp or LED display devices to indicate the button
status to the user.
The AXP-CPI16 default mode is STATUS-OFF, and in this mode the programmer cannot poll the AXP-
CPI16 to determine the state of the output channel. This is because in this mode the output and input
channels use the same number assignments. Inputs are sent by the AXP-CPI16 only as input changes.
When set for STATUS-ON mode the output channels are assigned a different channel number than the
input channels. This allows the programmer to monitor the status of an output channel. However the
channel offset must be accommodated in the programming code. Statements such as this example can be
used in a program.
IF[CPI16,25] (* output channel assigned to input channel 9 on P3 connector *)
Each of the two 20-pin connectors is assigned a group of 8 input and output channels. The table below
shows the relation of input and output channels in the STATUS modes.
The AXP-CPI16 may be configured to default to STATUS-ON mode using the following method. The
commands can force a change to the mode no matter what default mode is configured for the device.
STATUS-ON Mode:
Remove R7 (1K ohm) resistor OR short across R8 for STATUS-ON mode. Firmware remains the same
for standard and STATUS-ON mode AXP-CPI16 units.
Send_Commands
Command Description
'STATUS-ON'
Causes the AXP-CPI16 to be in Status-On Mode.
This command overrides the mode setting.
'STATUS-OFF'
Causes the AXP-CPI16 to be in Status-Off Mode.
This command overrides the mode setting.
Input/Output STATUS Mode
Mode Connector STATUS-OFF (default) STATUS-ON
Inputs P2 Chan 1-8 (Push/Release only) Chan 1-8 (On/Push/Off/Release)
P3 Chan 9-16 (On/Off only) Chan 17-24 (On/Off)
Outputs P2 Chan 1-8 (Push/Release only) Chan 9-16 (On/Push/Off/Release)
P3 Chan 9-16 (On/Off only) Chan 25-32 (On/Off)