Amwell Minima, Инструкции по ремонту

Страница: 2 / 20

Cleaning & Maintenance
Cleaning Laminate Components:
Always start by trying the gentlest method of cleaning. If a stain persists, work through the following steps,
repeating each step several times if the stain seems to be disappearing.
Step 1: For routine cleaning, use a damp cloth or sponge and a mild soap or detergent. Rinse the panels and
dry on completion.
Step 2: For dif
Step 3: If stubborn stains persist, use a non-scratch cleaner scrubbing lightly with a soft bristled brush for 10
to 20 seconds.
Step 4: If a stain persists, apply undiluted household bleach, let it stand for no longer then 2 minutes, and
rinse thoroughly with warm water. DO NOT expose the laminate surface to household bleach for prolonged
periods of time, as this may lead to permanent discolouration.
Step 5: If the surface has been discoloured through long expose to industrial grime, clean carefully with a
cream cleaner containing a mild abrasive.
DO: Always rinse thoroughly after cleaning (residue from cleaning solutions is the single greatest cause of
damage to laminate surfaces).
DO: Wipe up spills immediately, and rinse thoroughly.
DO NOT: use acidic or abrasive cleaners, expose the laminate to household bleach for prolonged periods of
Cleaning Ironmongery:
Powder Coated products should be cleaned at no more than three month intervals. Detergent diluted with
warm water should be used. A soft cloth, natural sponge or a soft bristle brush may be used. Abrasive
materials should be avoided. White spirit may be used to remove oil or grease deposits, but strong solvents
must be avoided. The coated items must be thoroughly rinsed following the use of detergents.
Metallic surfaces should be cleaned as detailed for powder coating. Care should be taken in order avoid
scratching the metallic surface.
Maintenance of Ironmongery
Cubicle locks and hinges should be wiped clean. A moderate amount of silicone type lubricant (such as
WD40) should be applied periodically to all moving parts, with any excess promptly removed. Excess use of
lubricants may attract dust, which will increase the wear rate of moving parts. It is imperative that the
as required.
General Comments:
In order to avoid water marks/ lime scale build up, standing water should be removed from horizontal
surfaces. Any water that has splashed onto a panel edge should be removed immediately.
Minima Page 2