GLORIFIER™ ACOUSTIC PREAMP DI
USER MANUAL
WWW.AMUMU.ROCKS
AMUMU.ROCKS
ALL RIGHTS RESERVED.
EAGLEVOX CORPORATION LIMITED
GAIN: Controls the Input Sensitivity from the instru-
ments and sets the amount of pre-amplification before
the signal enters the EQ section.
VOLUME: Located at the OUTPUT (the
very end of the circuit) and simply
allows you to adjust the volume.
BASS: Controls the amount of bass in
your signal. Left is less, right is more
MID: Controls the amount of mid
frequencies in your signal. Left is less,
right is more.
OUTPUT
(UNBALANCED):
1/4” Line Out with
mono plug to
connect with guitar
amplifier.
INPUT (MONO PLUG):
1/4” Line In with mono
plug to connect with
the acoustic-electric
instruments ( guitar,
bass, ukulele, cajon,
banjo, etc)
TREBLE: Controls the amount of treble in
your signal. Left is less, right is more.
Phase Switch: Reduce
feedback and also
Generate a fuller and
warmer tone.
48V: This LED will light
on when using with
phantom power only.
ON: This LED will light
on while using with any
of the 3 power
methods but only when
the INPUT jack is
plugged with a mono
D.I. OUTPUT (BALANCED): XLR DI output to
low-impedance devices like mixer, micro-
phone preamp, PA system and recording
consoles.
PS: The DI XLR output and the line output can
be used simultaneously. Either you can use
the 1/4" line out as a monitor for connecting
to a tuner or as a output for connecting the
guitar(instrument) amplifier while using the DI
output with a mixer or PA system.
MIXER
9V DC center
negative power
supply/adapter
