Amumu GLORIFIER Скачать руководство пользователя страница 1

GLORIFIER™ ACOUSTIC PREAMP DI

USER MANUAL

 

Thank you for choosing the AMUMU GLORIFIER™ acoustic preamp direct box. This preamp direct box is fully handcrafted with extremely 

low noise, excellent clarity, and warm EQ. It is designed for all acoustic-electric instruments with various pickups, especially, for all the 

AMUMU pickups. 

* AMUMU BOUNTIFUL™ series

* AMUMU SP30, SP31, SP60

* AMUMU SBT10, SBT12

PS: We offer a special discount for all the AMUMU pickups if you’ve owned the GLORIFIER™ preamp, just contact us for more info.

MAIN FEATURES

* Handcrafted Preamp DI Box for various acoustic-electric guitars with piezo, magnetic, under-saddle and microphone pickups

* +/-20 dB Gain control with 3-band EQ, Super-Low Noise and Sparkling Acoustic Clarity

* Phase Switch to reduce feedback and also to generate a fuller and warmer tone

* Powered by either 9V DC adapter(center negative), 48V phantom power or the 9-volt battery

* Convert high impedance unbalanced signal from the acoustic-electric instrument to low impedance balanced signal for the mixer, PA 

system, recording audio interface and microphone preamp. ( 1/4” Unbalanced Input to XLR Balanced DI Output plus a 1/4” Unbalanced 

Output )

POWER REQUIREMENTS

The AMUMU GLORIFIER™ Preamp DI can be powered by any of the following 3 methods. 

* Any standard 9V DC center negative power supply/adapter using a standard 2.1mm center pin and 5.5mm outside barrel (not included)

* 12V - 48V Phantom Power through D.I. output (XLR cable needed, Mixer/Audio Interface with built-in 48V phantom power needed)

* A PP3-size 9-volt battery (Alkaline 6LR61, not included)

    * Unscrew the bottom cover to install the battery

    * The battery will not be drained or charged when used with phantom power or DC adapter

    * Unplug the input cable when not using to power off the unit

INPUT

* INPUT (MONO PLUG): 1/4” Line In with mono plug from the acoustic-electric instruments ( Guitar, Bass, Ukulele, Cajon, Banjo, etc)

OUTPUTS

* OUTPUT (UNBALANCED): 1/4” Line Out with mono plug

* D.I. OUTPUT (BALANCED): XLR DI output to low-impedance devices like mixer, microphone preamp, PA system and recording consoles.

PS: The DI XLR output and the line output can be used simultaneously. Either you can use the 1/4" line out as a monitor for connecting to 

a tuner or as an output for connecting the guitar(instrument) amplifier while using the DI output with a mixer or PA system.

CONTROLS

* GAIN: Controls the Input Sensitivity from the instruments and sets the amount of pre-amplification before the signal enters the EQ 

section.

* VOLUME: Located at the OUTPUT (the very end of the circuit) and simply allows you to adjust the volume. 

* BASS: Controls the amount of bass in your signal. Left is less, right is more

* MID: Controls the amount of mid frequencies in your signal. Left is less, right is more.

* TREBLE: Controls the amount of treble in your signal. Left is less, right is more.

LEDS

* 48V: This LED will light on when used with phantom power only. 

* ON: This LED will light on while using with any of the 3 power methods but only when the INPUT jack is plugged with a mono cable.

SPECIFICATIONS

* Input Impedance : 1 Megohm (MΩ)

* D.I. Balanced Output Impedance (XLR): 100 Ohm (Ω)

* 1/4” Unbalanced Output Impedance: 100 Ohm (Ω)

* Frequency Response: 30Hz - 30kHz

* GAIN: +/-20 dB

* Expected Battery(Alkaline) life under continuous use: ~20-25 hours (depending on the actual conditions of use)

PRECAUTIONS WHEN CONNECTING

* To prevent malfunction and equipment failure, always turn down the VOLUME and turn off the power of your amplifier and other devices 

before making any connections.

* Once the connections have been completed, turn on the power to your various devices in the following order, otherwise, you risk 

causing malfunction and/or damage to speakers and other devices.

    * When powering up: Turn on the power of the amplifier last.

    * When powering down: Turn off the power of the amplifier first.

* Tone Controls: 

    * BASS: +/- 20 dB @ 100Hz

    * MID: +/- 20 dB @ 1.5kHz

    * TREBLE: +/- 20 dB @ 10kHz 

* Current Draw: 15mA average

WWW.AMUMU.ROCKS

[email protected]

AMUMU.ROCKS

ALL RIGHTS RESERVED. 

EAGLEVOX CORPORATION LIMITED

Отзывы: